From: Igor Opaniuk <[email protected]>
For Colibri iMX6ULL we have to set pinmux configuration ASAP (ideally
before relocation) to get serial console working. Without this we miss
almost the half of output (U-boot version, CPU defails, Reset cause,
DRAM details etc.).
To achieve this we need to force pinctrl-mx6 to get probed before
relocation. Setting pinmux configuration for UART before was done
in board_early_init_f().
Fixes: cd69e8ef9b ("colibri-imx6ull: migrate pinctrl and regulators to dtb/dm")
Signed-off-by: Igor Opaniuk <[email protected]>
---
drivers/pinctrl/nxp/pinctrl-imx6.c | 2 --
1 file changed, 2 deletions(-)
diff --git a/drivers/pinctrl/nxp/pinctrl-imx6.c
b/drivers/pinctrl/nxp/pinctrl-imx6.c
index 0c1e7a9c05..aafa3057ad 100644
--- a/drivers/pinctrl/nxp/pinctrl-imx6.c
+++ b/drivers/pinctrl/nxp/pinctrl-imx6.c
@@ -49,7 +49,5 @@ U_BOOT_DRIVER(imx6_pinctrl) = {
.remove = imx_pinctrl_remove,
.priv_auto_alloc_size = sizeof(struct imx_pinctrl_priv),
.ops = &imx_pinctrl_ops,
-#if !CONFIG_IS_ENABLED(OF_CONTROL)
.flags = DM_FLAG_PRE_RELOC,
-#endif
};
--
2.17.1
_______________________________________________
U-Boot mailing list
[email protected]
https://lists.denx.de/listinfo/u-boot
