The RX descriptor field 3 should contain only OWN and BUF1V bits before being used for receiving data by the DMA engine. However, right now, if the descriptor was already used for receiving data and is being cleared, the field 3 is only modified and the aforementioned two bits are ORRed into the field. This could lead to a residual dirty bits being left in the field 3 from previous transfer, and it generally does. Fully set the field 3 instead to clear those residual dirty bits.
Signed-off-by: Marek Vasut <[email protected]> Cc: Joe Hershberger <[email protected]> Cc: Patrice Chotard <[email protected]> Cc: Patrick Delaunay <[email protected]> Cc: Ramon Fried <[email protected]> Cc: Stephen Warren <[email protected]> --- drivers/net/dwc_eth_qos.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/dwc_eth_qos.c b/drivers/net/dwc_eth_qos.c index 0564bebf76..4bce6d4290 100644 --- a/drivers/net/dwc_eth_qos.c +++ b/drivers/net/dwc_eth_qos.c @@ -1242,7 +1242,7 @@ static int eqos_start(struct udevice *dev) struct eqos_desc *rx_desc = &(eqos->rx_descs[i]); rx_desc->des0 = (u32)(ulong)(eqos->rx_dma_buf + (i * EQOS_MAX_PACKET_SIZE)); - rx_desc->des3 |= EQOS_DESC3_OWN | EQOS_DESC3_BUF1V; + rx_desc->des3 = EQOS_DESC3_OWN | EQOS_DESC3_BUF1V; } eqos->config->ops->eqos_flush_desc(eqos->descs); @@ -1436,7 +1436,7 @@ static int eqos_free_pkt(struct udevice *dev, uchar *packet, int length) * writes to the rest of the descriptor too. */ mb(); - rx_desc->des3 |= EQOS_DESC3_OWN | EQOS_DESC3_BUF1V; + rx_desc->des3 = EQOS_DESC3_OWN | EQOS_DESC3_BUF1V; eqos->config->ops->eqos_flush_desc(rx_desc); writel((ulong)rx_desc, &eqos->dma_regs->ch0_rxdesc_tail_pointer); -- 2.25.1
