On 22.05.20 14:21, Jan Kiszka wrote: > On 22.05.20 13:38, Heinrich Schuchardt wrote: >> Am May 22, 2020 10:50:29 AM UTC schrieb Jan Kiszka <jan.kis...@siemens.com>: >>> On 22.05.20 12:42, Heinrich Schuchardt wrote: >>>> On 5/20/20 2:22 PM, Tom Rini wrote: >>>>> On Thu, May 07, 2020 at 08:36:03PM +0200, Jan Kiszka wrote: >>>>> >>>>>> From: Jan Kiszka <jan.kis...@siemens.com> >>>>>> >>>>>> This driver is safe to use in SPL without relocation. Denying >>>>>> DM_FLAG_PRE_RELOC prevents its usability for verifying the main >>> U-Boot >>>>>> or other artifacts from the SPL unless needless enabling the full >>> driver >>>>>> set (SPL_OF_PLATDATA). >>>>>> >>>>>> Fixes: 17e117408571 ("drivers: crypto: rsa_mod_exp: avoid >>> DM_FLAG_PRE_RELOC") >>>>>> CC: Heinrich Schuchardt <xypron.g...@gmx.de> >>>>>> CC: Marek Vasut <ma...@denx.de> >>>>>> Signed-off-by: Jan Kiszka <jan.kis...@siemens.com> >>>>> >>>>> Applied to u-boot/master, thanks! >>>>> >>>> >>>> With this patch applied pine64-lts_defconfig with CONFIG_RSA=y does >>> not >>>> boot anymore. See the output below. So something is wrong with this >>> driver. >>>> >>>> Do you have an idea how to analyze what is wrong? Unfortunately there >>> is >>>> no DEBUG_UART available on the Pine A64 LTS board. >>> >>> I would start crippling it down until things start to boot again. Are >>> you using it (for image verification e.g.), or is this just the >>> registration that breaks already? >>> >> >> >> RSA is needed in the UEFI subsystem for verifying variables and images. But >> there is no need in SPL for it at all. >> >> In my configuration RSA is not used at all. Something breaks before even the >> console becomes available. >> >> The pine64-lts_defconfig board boots via SPL->BL31->U-Boot > > But then a workaround for you would be to turn this driver off in SPL. > UEFI is main U-Boot only, isn't it? > > That said, understanding the reason for the breakage would still be nice > for the case someone needs to validate what SPL loads with the help of > RSA (which is the case for us on an AM65x board). > > Jan > As I described above I did *not* select RSA_SPL. The breakage is in main U-boot. SPL works fine loading TF-A BL31 which in turn loads U-Boot. But during driver initialization U-Boot does not even reach the point where we have a console due to something wrong with DM_FLAG_PRE_RELOC.
Best regards Heinrich