Am Sun, Feb 21, 2021 at 08:26:24AM -0800 schrieb Ye Li: > Setup USB clock in board codes, and enable the DWC3 XHCI and > PHY drivers to make USB3.0 host port working on i.MX8MQ EVK. > > Signed-off-by: Ye Li <[email protected]>
The same change works on the MNT Reform 2 as well. Reviewed-by: Patrick Wildt <[email protected]> > board/freescale/imx8mq_evk/imx8mq_evk.c | 4 ++++ > configs/imx8mq_evk_defconfig | 9 +++++++++ > 2 files changed, 13 insertions(+) > > diff --git a/board/freescale/imx8mq_evk/imx8mq_evk.c > b/board/freescale/imx8mq_evk/imx8mq_evk.c > index 93da67d..e394805 100644 > --- a/board/freescale/imx8mq_evk/imx8mq_evk.c > +++ b/board/freescale/imx8mq_evk/imx8mq_evk.c > @@ -86,6 +86,10 @@ int board_init(void) > setup_fec(); > #endif > > +#if defined(CONFIG_USB_DWC3) || defined(CONFIG_USB_XHCI_DWC3) > + init_usb_clk(); > +#endif > + > return 0; > } > > diff --git a/configs/imx8mq_evk_defconfig b/configs/imx8mq_evk_defconfig > index a149c1a..a644862 100644 > --- a/configs/imx8mq_evk_defconfig > +++ b/configs/imx8mq_evk_defconfig > @@ -54,3 +54,12 @@ CONFIG_DM_REGULATOR_GPIO=y > CONFIG_DM_RESET=y > CONFIG_MXC_UART=y > CONFIG_DM_THERMAL=y > +CONFIG_CMD_USB=y > +CONFIG_USB=y > +CONFIG_USB_STORAGE=y > +CONFIG_DM_USB=y > +CONFIG_USB_XHCI_HCD=y > +CONFIG_USB_XHCI_DWC3=y > +CONFIG_USB_DWC3=y > +CONFIG_PHY=y > +CONFIG_PHY_IMX8MQ_USB=y > -- > 2.7.4 >
