On Tuesday 14 December 2021 10:45:15 Marek Behún wrote: > On Tue, 14 Dec 2021 10:36:00 +0100 > Pali Rohár <[email protected]> wrote: > > > On Friday 26 November 2021 15:37:37 Marek Behún wrote: > > > @@ -340,17 +333,17 @@ void board_init_f(ulong dummy) > > > timer_init(); > > > > > > /* Armada 375 does not support SerDes and DDR3 init yet */ > > > -#if !defined(CONFIG_ARMADA_375) > > > - /* First init the serdes PHY's */ > > > - serdes_phy_config(); > > > - > > > - /* Setup DDR */ > > > - ret = ddr3_init(); > > > - if (ret) { > > > - debug("ddr3_init() failed: %d\n", ret); > > > - hang(); > > > + if (!IS_ENABLED(CONFIG_ARMADA_375)) { > > > + /* First init the serdes PHY's */ > > > + serdes_phy_config(); > > > + > > > + /* Setup DDR */ > > > + ret = ddr3_init(); > > > + if (ret) { > > > + debug("ddr3_init() failed: %d\n", ret); > > > + hang(); > > > + } > > > } > > > -#endif > > > > As written in comment above there is no SerDes and DDR3 support for > > Armada 375 and therefore there is no serdes_phy_config() or ddr3_init() > > function. So this code needs not to be compiled at all and usage of > > #ifdef is correct here. > > #ifdefs are almost never correct in C-files, for the parts of the code > they guard isn't put through syntactic analysis, and can therefore > contain bugs which we are not warned about. > > Using if (IS_ENABLED()) almost never producess a different binary, > because the code is optimized away. > > Marek
There is no function serdes_phy_config() for Armada 375, so if you put it outside of #ifdef you will get compile error.
