Hi Pali, On Tue, Dec 14, 2021 at 6:33 AM Pali Rohár <p...@kernel.org> wrote: > > On Saturday 11 December 2021 13:24:07 Tony Dinh wrote: > > Hi Pali, > > > > On Sat, Dec 11, 2021 at 7:39 AM Pali Rohár <p...@kernel.org> wrote: > > > > > > On Tuesday 16 November 2021 15:02:48 Tony Dinh wrote: > > > > Hi Pali, > > > > > > > > On Tue, Nov 16, 2021 at 2:37 PM Pali Rohár <p...@kernel.org> wrote: > > > > > > > > > > On Tuesday 16 November 2021 14:26:56 Tony Dinh wrote: > > > > > > Hi Pali, > > > > > > > > > > > > While we are at it, this default should be changed in > > > > > > drivers/usb/host/Kconfig. > > > > > > > > > > > > config USB_XHCI_MVEBU > > > > > > bool "MVEBU USB 3.0 support" > > > > > > default y > > > > > > > > > > > > Setting this default correctly will save a couple Kbytes for other > > > > > > boards. > > > > > > default y if ARCH_MVEBU > > > > > > > > > > Hello! USB_XHCI_MVEBU has currently "depends on ARCH_MVEBU" which > > > > > means > > > > > that USB_XHCI_MVEBU cannot be enabled when ARCH_MVEBU is disabled. So > > > > > "default y if ARCH_MVEBU" is same as "default y". > > > > > > > > Ah, thanks. This "depends on ARCH_MVEBU" was added in the latest > > > > master tree. I'm switching back and forth between the 2021.10 tag and > > > > master so I did not see this in the 2021.10 tree. > > > > > > Hello! Are you planning to send patches which add support for your > > > kirkwood board into mainline U-Boot? > > > > > > I would like to know if we should take care about that PCIe kirkwood > > > support as currently there is no board in mainline U-Boot which use PCIe > > > on kirkwood SoC. > > > > Yes, I plan to submit patches for the Pogoplug V4 (new board), and the > > Iomega iConnect board (update). So far the Pogoplug V4 PCIe is working > > perfectly with your in-progress patches. > > Ok! Because I'm going to do more changes in pci_mvebu.c driver and > kirkwood patch which I have sent to you would not work anymore.
OK! I have been testing my Pogoplug V4 patch series (almost done). Sounds like I should wait for your new patch to do more testing? Thanks, Tony > > > > > > > > > If you have mvebu board when mvebu xhci controller is unused, you can > > > > > disable this option and save some space. I see that other xhci drivers > > > > > have also "default y" so seems that this is the standard default > > > > > option.