Replace hardcoded i2c hex values for NOR banks by named SW macros in
map_lowernorbank/map_uppernorbank env commands.

Signed-off-by: Pali Rohár <[email protected]>
---
 include/configs/p1_p2_rdb_pc.h | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/include/configs/p1_p2_rdb_pc.h b/include/configs/p1_p2_rdb_pc.h
index cb3b1a1da05d..995bd983cef1 100644
--- a/include/configs/p1_p2_rdb_pc.h
+++ b/include/configs/p1_p2_rdb_pc.h
@@ -22,6 +22,9 @@
 #define __SW_BOOT_SD           0x9c
 #define __SW_BOOT_NAND         0xec
 #define __SW_BOOT_PCIE         0x6c
+#define __SW_NOR_BANK_MASK     0xfd
+#define __SW_NOR_BANK_UP       0x00
+#define __SW_NOR_BANK_LO       0x02
 #define CONFIG_SYS_L2_SIZE     (256 << 10)
 #endif
 
@@ -48,6 +51,9 @@
 #define __SW_BOOT_SD           0x24
 #define __SW_BOOT_NAND         0x44
 #define __SW_BOOT_PCIE         0x74
+#define __SW_NOR_BANK_MASK     0xfd
+#define __SW_NOR_BANK_UP       0x00
+#define __SW_NOR_BANK_LO       0x02
 #define CONFIG_SYS_L2_SIZE     (256 << 10)
 /*
  * Dynamic MTD Partition support with mtdparts
@@ -64,6 +70,9 @@
 #define __SW_BOOT_SD2          0x18
 #define __SW_BOOT_NAND         0xe8
 #define __SW_BOOT_PCIE         0xa8
+#define __SW_NOR_BANK_MASK     0xfd
+#define __SW_NOR_BANK_UP       0x00
+#define __SW_NOR_BANK_LO       0x02
 #define CONFIG_SYS_L2_SIZE     (512 << 10)
 /*
  * Dynamic MTD Partition support with mtdparts
@@ -617,8 +626,8 @@ i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 3 __SW_BOOT_MASK 1; reset
 "nandfdtaddr=80000\0"          \
 "ramdisk_size=120000\0"        \
 __VSCFW_ADDR   \
-"map_lowernorbank=i2c dev "__stringify(CONFIG_SYS_SPD_BUS_NUM)"; i2c mw 
"__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 1 02 1; i2c mw 
"__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 3 fd 1\0" \
-"map_uppernorbank=i2c dev "__stringify(CONFIG_SYS_SPD_BUS_NUM)"; i2c mw 
"__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 1 00 1; i2c mw 
"__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 3 fd 1\0" \
+"map_lowernorbank=i2c dev "__stringify(CONFIG_SYS_SPD_BUS_NUM)"; i2c mw 
"__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 1 "__stringify(__SW_NOR_BANK_LO)" 1; 
i2c mw "__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 3 
"__stringify(__SW_NOR_BANK_MASK)" 1\0" \
+"map_uppernorbank=i2c dev "__stringify(CONFIG_SYS_SPD_BUS_NUM)"; i2c mw 
"__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 1 "__stringify(__SW_NOR_BANK_UP)" 1; 
i2c mw "__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 3 
"__stringify(__SW_NOR_BANK_MASK)" 1\0" \
 __stringify(__NOR_RST_CMD)"\0" \
 __stringify(__SPI_RST_CMD)"\0" \
 __stringify(__SD_RST_CMD)"\0" \
-- 
2.20.1

Reply via email to