Whole section about USB/eLBC configuration seems to be P1020 specific. So add ifdefs to not compile it on other platforms (e.g. P2020).
Signed-off-by: Pali Rohár <[email protected]> --- board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c b/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c index fc581bdb2a40..1b28f1bbc776 100644 --- a/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c +++ b/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c @@ -354,9 +354,9 @@ int ft_board_setup(void *blob, struct bd_info *bd) #if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC) const char *soc_usb_compat = "fsl-usb2-dr"; int usb_err, usb1_off, usb2_off; -#endif #if defined(CONFIG_SDCARD) || defined(CONFIG_SPIFLASH) int err; +#endif #endif ft_cpu_setup(blob, bd); @@ -375,6 +375,7 @@ int ft_board_setup(void *blob, struct bd_info *bd) fsl_fdt_fixup_dr_usb(blob, bd); #endif +#if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC) #if defined(CONFIG_SDCARD) || defined(CONFIG_SPIFLASH) /* Delete eLBC node as it is muxed with USB2 controller */ if (hwconfig("usb2")) { @@ -396,7 +397,6 @@ int ft_board_setup(void *blob, struct bd_info *bd) } #endif -#if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC) /* Delete USB2 node as it is muxed with eLBC */ usb1_off = fdt_node_offset_by_compatible(blob, -1, soc_usb_compat); -- 2.20.1
