Hello, I built u-boot-2010.09 for Freescale's P2020-RDB.
It works great !!! The setup I used for SW4 is according to the startup guide. SW4[7] is on. When SW4[7] is off u-boot hangs. It means: "boot sequencer enabled and configuration information loaded from I2C ROM. A valid ROM must be present. If not the card will hang". I do not need the I2C ROM but for some reason, vxWorks 6.8 needs it. I'm using u-boot to download vxWorks via tftp and run it (using bootelf) What does u-boot hangs when SW4[7] is off ? What should this I2C ROM contain ? How can I flash this ROM ? According to the manual, this board contains I2C ROM. Thanks, Zvika Vered _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
