This option is used only by the phy-sun4i-usb driver, which does not
inherently depend on the ARM architecture.
Signed-off-by: Samuel Holland <sam...@sholland.org>
---
arch/arm/mach-sunxi/Kconfig | 9 ---------
drivers/phy/allwinner/Kconfig | 10 ++++++++++
2 files changed, 10 insertions(+), 9 deletions(-)
diff --git a/arch/arm/mach-sunxi/Kconfig b/arch/arm/mach-sunxi/Kconfig
index 71a7f8dcee06..4a833d37a841 100644
--- a/arch/arm/mach-sunxi/Kconfig
+++ b/arch/arm/mach-sunxi/Kconfig
@@ -679,15 +679,6 @@ config MMC_SUNXI_SLOT_EXTRA
slot or emmc on mmc1 - mmc3. Setting this to 1, 2 or 3 will enable
support for this.
-config INITIAL_USB_SCAN_DELAY
- int "delay initial usb scan by x ms to allow builtin devices to init"
- default 0
- ---help---
- Some boards have on board usb devices which need longer than the
- USB spec's 1 second to connect from board powerup. Set this config
- option to a non 0 value to add an extra delay before the first usb
- bus scan.
-
config USB0_VBUS_PIN
string "Vbus enable pin for usb0 (otg)"
default ""
diff --git a/drivers/phy/allwinner/Kconfig b/drivers/phy/allwinner/Kconfig
index d3ff82f73a00..f8f1e99c4f52 100644
--- a/drivers/phy/allwinner/Kconfig
+++ b/drivers/phy/allwinner/Kconfig
@@ -13,6 +13,16 @@ config PHY_SUN4I_USB
This driver controls the entire USB PHY block, both the USB OTG
parts, as well as the 2 regular USB 2 host PHYs.
+config INITIAL_USB_SCAN_DELAY
+ int "Delay initial USB scan by x ms to allow builtin devices to init"
+ depends on PHY_SUN4I_USB
+ default 0
+ help
+ Some boards have on board usb devices which need longer than
+ the USB spec's 1 second to connect from board powerup. Set
+ this option to a nonzero value to add an extra delay before
+ the first USB bus scan.
+
config PHY_SUN50I_USB3
bool "Allwinner sun50i USB3 PHY driver"
depends on ARCH_SUNXI
--
2.35.1
