On 4/3/23 06:42, Tony Dinh wrote:
- DDR Training sequence happens very fast. The speedup in boot time is
negligible by skipping the training sequence during 2nd boot or after.
So remove the check and skip.
- This change improves the robustness of DDR training. If u-boot crashed
during DDR training, the training could be left in a limbo state, where
the BootROM has recorded that it is already in a 2nd boot. The training
must be repeated in this scenario to get out of this limbo state, but due
to the check it cannot be performed.
Signed-off-by: Tony Dinh <[email protected]>
Applied to u-boot-marvell/master
Thanks,
Stefan
---
drivers/ddr/marvell/a38x/mv_ddr_plat.c | 7 -------
1 file changed, 7 deletions(-)
diff --git a/drivers/ddr/marvell/a38x/mv_ddr_plat.c
b/drivers/ddr/marvell/a38x/mv_ddr_plat.c
index 6e7949ac72..8ec9fb0874 100644
--- a/drivers/ddr/marvell/a38x/mv_ddr_plat.c
+++ b/drivers/ddr/marvell/a38x/mv_ddr_plat.c
@@ -1363,13 +1363,6 @@ int mv_ddr_pre_training_soc_config(const char *ddr_type)
DRAM_RESET_MASK_MASKED << DRAM_RESET_MASK_OFFS);
}
- /* Check if DRAM is already initialized */
- if (reg_read(REG_BOOTROM_ROUTINE_ADDR) &
- (1 << REG_BOOTROM_ROUTINE_DRAM_INIT_OFFS)) {
- printf("%s Training Sequence - 2nd boot - Skip\n", ddr_type);
- return MV_OK;
- }
-
/* Fix read ready phases for all SOC in reg 0x15c8 */
reg_val = reg_read(TRAINING_DBG_3_REG);
Viele Grüße,
Stefan Roese
--
DENX Software Engineering GmbH, Managing Director: Erika Unter
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: [email protected]
