On Tue, 2011-02-08 at 10:52 -0600, Kumar Gala wrote:
> > +#endif
> >
> > uec = (uec_private_t *)dev->priv;
> >
> > if (uec->the_first_run == 0) {
> > +#ifdef CONFIG_P1021
> > + /* reset micrel phy for each UEC */
> > + clrbits_8((u8 *)(CONFIG_SYS_BCSR_BASE + 11), BCSR11_ENET_MICRST);
> > + udelay(200);
> > + setbits_8((u8 *)(CONFIG_SYS_BCSR_BASE + 11), BCSR11_ENET_MICRST);
> > +
>
> Hmm, this is board specific, can we not do this in board_*_f or _r?
>
It did not work to do this in board_*_f/r. The board designer to me to
reset the phy before initializing it for each UEC separately. Here is
the right place to do so.
Haiying
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
