[PATCH 2/5] arm: dts: sc598: add missing GPIO hogs for Rev D

[ozndrgt]

From: Ozan Durgut <ozan.dur...@analog.com>

Add missing GPIO hogs for UART0 enable, UART0 flow control,
SD Card and eMMC control signals.

Fixes: c9e893d ("board: adi: Add support for SC598")
Signed-off-by: Ozan Durgut <ozan.dur...@analog.com>
---
 arch/arm/dts/sc598-som-revD.dtsi | 32 ++++++++++++++++++++++++++++++++
 1 file changed, 32 insertions(+)

diff --git a/arch/arm/dts/sc598-som-revD.dtsi b/arch/arm/dts/sc598-som-revD.dtsi
index bf1ef88cb58..26e272966ff 100644
--- a/arch/arm/dts/sc598-som-revD.dtsi
+++ b/arch/arm/dts/sc598-som-revD.dtsi
@@ -55,6 +55,38 @@
                        line-name = "spi2flash-cs";
                        bootph-pre-ram;
                };
+
+               uart0 {
+                       gpio-hog;
+                       gpios = <5 GPIO_ACTIVE_LOW>;
+                       output-high;
+                       line-name = "uart0-en";
+                       bootph-pre-ram;
+               };
+
+               uart0-flow-en {
+                       gpio-hog;
+                       gpios = <6 GPIO_ACTIVE_LOW>;
+                       output-low;
+                       line-name = "uart0-flow-en";
+                       bootph-pre-ram;
+               };
+
+               som-emmc {
+                       gpio-hog;
+                       gpios = <8 GPIO_ACTIVE_LOW>;
+                       output-high;
+                       line-name = "som-emmc-en";
+                       bootph-pre-ram;
+               };
+
+               crr-sdcard {
+                       gpio-hog;
+                       gpios = <9 GPIO_ACTIVE_LOW>;
+                       output-low;
+                       line-name = "crr-sdcard-en";
+                       bootph-pre-ram;
+               };
        };
 };
 
-- 
2.43.0