Endpoints should not be disabled on bus reset inside UDC driver,
otherwise a race condition will happen between gadget driver. Gadget
driver will free the requests and disable endpoints in disconnect ops.

Also remove outdated comment about it in usba_ep_disable().

Fixes: 59310d1ecb9f ("usb: gadget: introduce 'enabled' flag in struct usb_ep")

Signed-off-by: Zixun LI <[email protected]>
---
Changes in v2:
- Remove outdated comment in usba_ep_disable()
- Reword commit message
- Link to v1: 
https://patch.msgid.link/[email protected]

To: Mattijs Korpershoek <[email protected]>
To: Stephan Gerhold <[email protected]>
To: [email protected]
Cc: Lukasz Majewski <[email protected]>
Cc: Marek Vasut <[email protected]>
Cc: Tom Rini <[email protected]>
Cc: Zixun LI <[email protected]>
Cc: Andrew Goodbody <[email protected]>
---
 drivers/usb/gadget/atmel_usba_udc.c | 18 ------------------
 1 file changed, 18 deletions(-)

diff --git a/drivers/usb/gadget/atmel_usba_udc.c 
b/drivers/usb/gadget/atmel_usba_udc.c
index f7a92ded6da..a2eee2bca2c 100644
--- a/drivers/usb/gadget/atmel_usba_udc.c
+++ b/drivers/usb/gadget/atmel_usba_udc.c
@@ -289,10 +289,6 @@ static int usba_ep_disable(struct usb_ep *_ep)
 
        if (!ep->desc) {
                spin_unlock_irqrestore(&udc->lock, flags);
-               /* REVISIT because this driver disables endpoints in
-                * reset_all_endpoints() before calling disconnect(),
-                * most gadget drivers would trigger this non-error ...
-                */
                if (udc->gadget.speed != USB_SPEED_UNKNOWN)
                        DBG(DBG_ERR, "ep_disable: %s not enabled\n",
                            ep->ep.name);
@@ -571,20 +567,6 @@ static void reset_all_endpoints(struct usba_udc *udc)
                list_del_init(&req->queue);
                request_complete(ep, req, -ECONNRESET);
        }
-
-       /* NOTE:  normally, the next call to the gadget driver is in
-        * charge of disabling endpoints... usually disconnect().
-        * The exception would be entering a high speed test mode.
-        *
-        * FIXME remove this code ... and retest thoroughly.
-        */
-       list_for_each_entry(ep, &udc->gadget.ep_list, ep.ep_list) {
-               if (ep->desc) {
-                       spin_unlock(&udc->lock);
-                       usba_ep_disable(&ep->ep);
-                       spin_lock(&udc->lock);
-               }
-       }
 }
 
 static struct usba_ep *get_ep_by_addr(struct usba_udc *udc, u16 wIndex)

---
base-commit: 5732bd0f457b4c671e46574d64d4acb099c0f0a5
change-id: 20260512-udc_ep-51a3f7a6befb

Best regards,
--  
Zixun LI <[email protected]>

Reply via email to