Switch the nfsboot and other relevant commands to use wget instead of tftp. This also includes the addition of the httpdstp variable for selecting the wget port.
There is no longer any automatic DHCP configuration. Before running a command with wget, either 'dhcp' must be run or the 'ipaddr' and 'serverip' variables must be set. Additionally, the nfsboot command looks for the file named 'fitImage' on the server to use to boot. The default port is set to 8000 instead of the usual 80 to allow for use with an unprivileged web server. Signed-off-by: Caleb Ethridge <[email protected]> --- include/env/adi/adi_boot.env | 11 +++++------ 1 file changed, 5 insertions(+), 6 deletions(-) diff --git a/include/env/adi/adi_boot.env b/include/env/adi/adi_boot.env index b4b725247f7..be4d8521ac9 100644 --- a/include/env/adi/adi_boot.env +++ b/include/env/adi/adi_boot.env @@ -14,6 +14,7 @@ /* Config options */ ethaddr=02:80:ad:20:31:e8 eth1addr=02:80:ad:20:31:e9 +httpdstp=8000 uart_console=CONFIG_UART_CONSOLE #ifdef CONFIG_SC59X_64 initrd_high=0xffffffffffffffff @@ -26,15 +27,14 @@ adi_bootargs=EARLY_PRINTK console=ttySC0,CONFIG_BAUDRATE vmalloc=512M ramargs=setenv bootargs ${adi_bootargs} addip=setenv bootargs ${bootargs} ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:${hostname}:eth0:off +rootpath=/romfs /* Boot modes are selectable and should be defined in the board env before including */ #if defined(USE_NFS) -// rootpath is set by CONFIG_ROOTPATH nfsargs=setenv bootargs root=/dev/nfs rw nfsroot=${serverip}:${rootpath},tcp,nfsvers=3 ${adi_bootargs} -nfsboot=run init_ethernet; - tftp ${loadaddr} ${tftp_dir_prefix}${imagefile}; - run nfsargs; +nfsboot=run nfsargs; run addip; + wget ${loadaddr} ${serverip}:/fitImage; bootm ${loadaddr} #endif @@ -63,8 +63,7 @@ ospiboot=run ospiargs; #endif #if defined(USE_RAM) -ramboot=run init_ethernet; - tftp ${loadaddr} ${tfpt_dir_prefix}${imagefile}; +ramboot=wget ${loadaddr} ${serverip}:/fitImage; run ramargs; bootm ${loadaddr} #endif -- 2.34.1
