The 4.2.2 gcc in the ELDK42 release doesn't like the direct SP load using a constant in tegra2_start. Break it up into 4 loads using mov & orr.
Tested on my Seaboard T20-A03, U-Boot loads and runs OK. Also compiled all tegra2 builds with both gcc 4.2.2 and 4.4.1 OK. Signed-off-by: Tom Warren <[email protected]> --- arch/arm/cpu/armv7/tegra2/ap20.c | 25 ++++++++++++++++++++----- 1 files changed, 20 insertions(+), 5 deletions(-) diff --git a/arch/arm/cpu/armv7/tegra2/ap20.c b/arch/arm/cpu/armv7/tegra2/ap20.c index 4c44bb3..d2bc0d5 100644 --- a/arch/arm/cpu/armv7/tegra2/ap20.c +++ b/arch/arm/cpu/armv7/tegra2/ap20.c @@ -298,11 +298,26 @@ void tegra2_start(void) writel(0xC0, &pmt->pmt_cfg_ctl); /* - * If we are ARM7 - give it a different stack. We are about to - * start up the A9 which will want to use this one. - */ - asm volatile("ldr sp, =%c0\n" - : : "i"(AVP_EARLY_BOOT_STACK_LIMIT)); + * If we are ARM7 - give it a different stack. We are about to + * start up the A9 which will want to use this one. + */ + /* + * Note that the 'ldr sp,CONSTANT' version, below, doesn't + * work on gcc 4.2.2 (ELDK42), but does on gcc 4.4.1 and above. + * The work-around is to use the (ugly) 4-pass mov/orr below. + * + * asm volatile("ldr sp, =%c0\n" : : + * "i"(AVP_EARLY_BOOT_STACK_LIMIT)); + */ + + asm volatile("mov sp, %0" + : : "i"(AVP_EARLY_BOOT_STACK_LIMIT & 0xFF)); + asm volatile("orr sp, %0" + : : "i"(AVP_EARLY_BOOT_STACK_LIMIT & 0xFF00)); + asm volatile("orr sp, %0" + : : "i"(AVP_EARLY_BOOT_STACK_LIMIT & 0xFF0000)); + asm volatile("orr sp, %0" + : : "i"(AVP_EARLY_BOOT_STACK_LIMIT & 0xFF000000)); start_cpu((u32)_start); halt_avp(); -- 1.7.7.1 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
