On Wed, Aug 8, 2012 at 12:52 PM, Mike Frysinger <[email protected]> wrote: > On Tuesday 07 August 2012 04:07:43 Bob Liu wrote: >> --- a/arch/blackfin/include/asm/config-pre.h >> +++ b/arch/blackfin/include/asm/config-pre.h >> >> #define BFIN_BOOT_16HOST_DMA 11 /* boot ldr from 16-bit host dma */ >> #define BFIN_BOOT_8HOST_DMA 12 /* boot ldr from 8-bit host dma */ >> #define BFIN_BOOT_NAND 13 /* boot ldr from nand flash */ >> +#define BFIN_BOOT_RSI_MASTER 14 /* boot ldr from rsi */ >> +#define BFIN_BOOT_LP_SLAVE 15 /* boot ldr from link port */ >> >> case BFIN_BOOT_16HOST_DMA: return "16bit dma"; >> case BFIN_BOOT_8HOST_DMA: return "8bit dma"; >> case BFIN_BOOT_NAND: return "nand flash"; >> + case BFIN_BOOT_RSI_MASTER: return "rsi master"; >> + case BFIN_BOOT_LP_SLAVE: return "link port slave"; >> default: return "INVALID"; >> } >> } > > seems like a change that should be by itself, or squashed into the "core bf60x > support" patch > >> --- a/arch/blackfin/include/asm/mach-common/bits/dma.h >> +++ b/arch/blackfin/include/asm/mach-common/bits/dma.h > > should be part of the "bf60x dma" patch > >> --- a/arch/blackfin/include/asm/mach-common/bits/sdh.h >> +++ b/arch/blackfin/include/asm/mach-common/bits/sdh.h >> --- a/drivers/mmc/bfin_sdh.c >> +++ b/drivers/mmc/bfin_sdh.c > > these are about the only changes that should be in this patch, and the subject > should be: > Blackfin: rsi: add support for bf60x > >> --- a/board/bf609-ezkit/bf609-ezkit.c >> +++ b/board/bf609-ezkit/bf609-ezkit.c >> --- a/include/configs/bf609-ezkit.h >> +++ b/include/configs/bf609-ezkit.h > > merge the rsi patch first, then squash this into the bf609-ezkit board patch
Okay. -- Regards, --Bob _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
