If you're on AIX, there are some settings in smit that may be causing it too.
Sincerely, David Laansma IT Manager Hubbard Supply Co. Direct: 810-342-7143 Office: 810-234-8681 Fax: 810-234-6142 www.hubbardsupply.com "Delivering Products, Services and Innovative Solutions" -----Original Message----- From: u2-users-boun...@listserver.u2ug.org [mailto:u2-users-boun...@listserver.u2ug.org] On Behalf Of John Thompson Sent: Thursday, December 22, 2011 3:14 PM To: U2 Users List Subject: Re: [U2] Line Printer Control If I remember correctly, when we converted from UltPlus to Universe... I had to set the following in our master login paragraph (I know, I know, probably not the best place for it) for a lot of legacy stuff. SETPTR ,132,60,0,0,,NOHEAD,BRIEF,NFMT Try that maybe? Shot in the dark. I do remember many hours pulling my hair out over this though. On Thu, Dec 22, 2011 at 3:06 PM, Bill Brutzman <bi...@hkmetalcraft.com>wrote: > We still use a greenbar printer to print checks. > > Via a UniBasic program, I am trying to send an alignment pattern to > the printer before starting the check run. > > The trouble is that it always does a form feed after the alignment pattern. > > I have been diddling with toggling options in... > > execute 'SETPTR > 0,132,60,2,0,1,NHEAD,BRIEF,NFMT,NOEJECT,NODEFAULT,NOFORMFEED, AT PR0' > > PRINTER OFF > PRINTER CLOSE > > Help would be appreciated. > > --Bill > _______________________________________________ > U2-Users mailing list > U2-Users@listserver.u2ug.org > http://listserver.u2ug.org/mailman/listinfo/u2-users > -- John Thompson _______________________________________________ U2-Users mailing list U2-Users@listserver.u2ug.org http://listserver.u2ug.org/mailman/listinfo/u2-users _______________________________________________ U2-Users mailing list U2-Users@listserver.u2ug.org http://listserver.u2ug.org/mailman/listinfo/u2-users