Hi Everyone, Does a DCOUNT get evaluated again for each iteration of a loop? Or is UniVerse these days intelligent enough to keep track of what's going on?
e.g. for i = 1 to dcount(array,@fm) *commands here next i versus totalattributes = dcount(array,@fm) for i = 1 to totalattributes *commands here next i Apart from readability and perhaps easier debugging is there an actual internal difference? I know it was an issue on older pick releases but I cannot remember if it ever affected UV? Cheers Peter ------------------------------------------------------------------------------- Note: This email (inc all attachments) is for the use of the intended recipient(s) only. Privileged or confidential information may be contained in this communication. If you have received this email in error, please notify the sender immediately and then delete all copies of this message from your computer network. If you are not the intended recipient, you must not keep, use, disclose, copy or distribute this email without the author's prior permission. If you are the intended recipient and you do not wish to receive similar electronic messages from us in future, then please respond to the sender to this effect. We have taken precautions to minimise the risk of transmitting software viruses, but advise you to carry out your own virus checks on this email and its attachments. We do not accept liability for any loss or damage caused by software viruses and do not represent that this transmission is free from viruses or other defects. Firstmac Limited (ABN 59 094 145 963) (AFSL 290600) ------------------------------------------------------------------------------- _______________________________________________ U2-Users mailing list U2-Users@listserver.u2ug.org http://listserver.u2ug.org/mailman/listinfo/u2-users