I had one at home do the exact same thing this weekend. I was able to
do the firmware recovery (I think), as it accepted a tftp upload after
holding the reset for 8 seconds after power-on. The two ports I had PoE
enabled on did turn on once a couple of reboots after the recovery, but
then stopped again. I haven't had a chance to mess with it more, but
you're not alone.
-Kristian
On 10/27/2014 03:16 PM, Mike Hammett wrote:
It no longer does PoE on the ports its supposed to be doing PoE on.
Not showing up in the discovery tool anymore.
Management port link light on when no cable plugged in.
Switches traffic just fine.
I can't figure out how to get into it (it doesn't respond to
19.2.168.1.20 as if it reset to defaults either).
Dead?
-----
Mike Hammett
Intelligent Computing Solutions
http://www.ics-il.com
<https://www.facebook.com/ICSIL><https://plus.google.com/+IntelligentComputingSolutionsDeKalb><https://www.linkedin.com/company/intelligent-computing-solutions><https://twitter.com/ICSIL>
_______________________________________________
Ubnt_users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/ubnt_users
_______________________________________________
Ubnt_users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/ubnt_users
