Disable channel shifting on the 4.03 units and try again.
The legacy gear channel shifting is opposite from the M gear.
I hope that is sorta clear.
On 1/1/2015 5:28 PM, Chris Soiles wrote:
Encountered a problem today, don't know if it is known
Have a Micropop using 20Mhz with Channel Shifting Disabled
Started dealing with noise floor issues, so I changed o the config to
my standard Micropop config
10Mhz with Channel Shifting Enabled, I have 10 subs on this tower, 7
of them were PicostationM and NanoBridges, but I had a couple from
when it was first turned up, that had Nanostation Locos and a Bullet2
Changed their Wireless setting to 10Mhz and Enabled channel shifting,
rebooted and nothing
Went into the Wireless Tab and did the Search and they didn't hear any
SSIDs
Figured it was a config problem, but couldn't get anything with 4.0.3
to connect to 10Mhz and Channel Shifting
Any ideas?
--
Chris Soiles
Rio Cities
[email protected] <mailto:[email protected]>
505-966-6389
_______________________________________________
Ubnt_users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/ubnt_users
_______________________________________________
Ubnt_users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/ubnt_users
