Eh...mebbe so....no more legacy gear here to check, but that was how it
used to be....
On 1/1/2015 9:58 PM, Josh Luthman wrote:
That was changed in a 5.5 mid release I think
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Jan 1, 2015 9:55 PM, "Jerry Head" <[email protected]
<mailto:[email protected]>> wrote:
Disable channel shifting on the 4.03 units and try again.
The legacy gear channel shifting is opposite from the M gear.
I hope that is sorta clear.
On 1/1/2015 5:28 PM, Chris Soiles wrote:
Encountered a problem today, don't know if it is known
Have a Micropop using 20Mhz with Channel Shifting Disabled
Started dealing with noise floor issues, so I changed o the
config to my standard Micropop config
10Mhz with Channel Shifting Enabled, I have 10 subs on this
tower, 7 of them were PicostationM and NanoBridges, but I had a
couple from when it was first turned up, that had Nanostation
Locos and a Bullet2
Changed their Wireless setting to 10Mhz and Enabled channel
shifting, rebooted and nothing
Went into the Wireless Tab and did the Search and they didn't
hear any SSIDs
Figured it was a config problem, but couldn't get anything with
4.0.3 to connect to 10Mhz and Channel Shifting
Any ideas?
--
Chris Soiles
Rio Cities
[email protected] <mailto:[email protected]>
505-966-6389 <tel:505-966-6389>
_______________________________________________
Ubnt_users mailing list
[email protected] <mailto:[email protected]>
http://lists.wispa.org/mailman/listinfo/ubnt_users
_______________________________________________
Ubnt_users mailing list
[email protected] <mailto:[email protected]>
http://lists.wispa.org/mailman/listinfo/ubnt_users
_______________________________________________
Ubnt_users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/ubnt_users
_______________________________________________
Ubnt_users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/ubnt_users
