I did. -87 or so at the worst. I get 1 ms pings from the radios to Ethernet devices on their respective sides. The low throughput and high latency only seems to affect traffic going over the wireless link.
The near side of the link is fairly new. The other side is probably five years old. Unknown on the voltage. No other reported issues in that area. PCs, VoIP phones, etc. working as expected. Well, other than network issues. I think they start work at 7:30, so I would guess that it was fine for at least some time until then. Didn't get What's Up notifications of issues until nearly 10, so it wasn't dog shit terrible until then. ----- Mike Hammett Intelligent Computing Solutions Midwest Internet Exchange The Brothers WISP ----- Original Message ----- From: "Scott Lambert" <[email protected]> To: "Ubiquiti Users Group" <[email protected]> Sent: Thursday, November 24, 2016 12:12:49 AM Subject: Re: [Ubnt_users] Great CCQ, AMC, AMQ, etc. shit throughput On Wed, Nov 23, 2016 at 08:18:45PM -0600, Mike Hammett wrote: > It worked until 8 AM this morning deployed. > I know you said noise was unlikely. Can you run an AirView anyway to make sure? I suspect your air rates would be in the toilet if there was anything making enough noise to slow your throughput this much. Unless maybe, WAG, it's really narrow band FHSS? You didn't mention it, but I assume you've checked that the ethernet negotiation is correct at both ends? Any possibility voltage is down into brownout range? It was like someone flipped a switch and throughput went to heck at 8:00? Or customer came in at 8 and throughput was bad, problem may have come about between 5pm yesterday and this morning? How old is the gear? > ----- Original Message ----- > > From: "Kees H" <[email protected]> > To: "Ubiquiti Users Group" <[email protected]> > Sent: Wednesday, November 23, 2016 5:17:58 PM > Subject: Re: [Ubnt_users] Great CCQ, AMC, AMQ, etc. shit throughput > > > > Did the link work in the office? > > From: Mike Hammett > Sent: Wednesday, November 23, 2016 9:47 AM > To: Ubiquiti Users Group > Subject: [Ubnt_users] Great CCQ, AMC, AMQ, etc. shit throughput > > > I have a link that's a couple hundred feet. -57 or so signal with > balanced chains. CCQ, AMC and AMQ are all above 95%. I only can get > double digit KILObit throughput one direction. I've rebooted, upgraded > to 5.6.9, sent in support files, checked CPU usage, etc. Modulations > are 130/130 on 20 MHz (was at least 240/240, usually 270/300 on 40 > MHz). The worst noise in the area is probably -87. > > > I have no clue. -- Scott Lambert KC5MLE Unix SysAdmin [email protected] _______________________________________________ Ubnt_users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/ubnt_users
_______________________________________________ Ubnt_users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/ubnt_users
