Hello Larry, I upgrade to intrepid and I try, here is the dmesg, wifi led is on but no wifi is detecting... here is the dmesg,
hp-dmi module is not in Intrepid?? [10632.392560] ACPI: PCI Interrupt Link [LNK3] enabled at IRQ 17 [10632.392589] b43-pci-bridge 0000:02:02.0: PCI INT A -> Link[LNK3] -> GSI 17 (level, low) -> IRQ 17 [10632.403353] ssb: Sonics Silicon Backplane found on PCI device 0000:02:02.0 [10632.675659] Broadcom 43xx driver loaded [ Features: PLR, Firmware-ID: FW13 ] [10633.012751] b43legacy-phy0: Broadcom 4301 WLAN found [10633.036066] b43legacy-phy0 debug: Found PHY: Analog 0, Type 1, Revision 4 [10633.036103] b43legacy-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2 [10633.060054] b43legacy-phy0 debug: Radio initialized [10633.065352] phy0: Selected rate control algorithm 'pid' [10633.311057] b44.c:v2.0 [10633.311095] b44: Invalid MAC address found in EEPROM [10633.311104] b44 ssb0:1: Problem fetching invariants of chip, aborting. [10633.312086] b44: probe of ssb0:1 failed with error -22 [10633.313458] Broadcom 43xx-legacy driver loaded [ Features: PLRID, Firmware-ID: FW10 ] [10633.345995] udev: renamed network interface wlan0 to wlan1 [10638.469515] input: b43legacy-phy0 as /devices/virtual/input/input17 [10638.536065] firmware: requesting b43legacy/ucode2.fw [10638.634334] firmware: requesting b43legacy/pcm4.fw [10638.649320] firmware: requesting b43legacy/b0g0initvals2.fw [10638.804262] b43legacy-phy0: Loading firmware version 0x127, patch level 14 (2005-04-18 02:36:27) [10638.904307] b43legacy-phy0 debug: Chip initialized [10638.906367] b43legacy-phy0 debug: 30-bit DMA initialized [10638.911898] Registered led device: b43legacy-phy0:tx [10638.912483] Registered led device: b43legacy-phy0:rx [10638.912918] Registered led device: b43legacy-phy0:radio [10638.912982] b43legacy-phy0 debug: Wireless interface started [10638.928090] b43legacy-phy0 debug: Adding Interface type 2 [10638.940194] ADDRCONF(NETDEV_UP): wlan1: link is not ready [10639.488040] b43legacy-phy0: Radio hardware status changed to DISABLED [10639.489528] b43legacy-phy0 debug: Radio initialized [10639.552034] b43legacy-phy0: Radio turned on by software [10639.552052] b43legacy-phy0: The hardware RF-kill button still turns the radio physically off. Press the button to turn it on. -- No wifi with b43legacy https://bugs.launchpad.net/bugs/238896 You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. -- ubuntu-bugs mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
