-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hello,
I can run the firebox very well in Ubuntustudio but I have to say, that it works much better in 64Studio - I have random crashes of freebob frequently in Ubuntustudio 32bit and not a single xrun even with extreme load in 64Studio. Last Week I had a 8h-Recordingsession with a band, my laptop, the firebox and 64Studio and there was a single crash of freebob while exporting a 30min-Track from a 96KHz-Ardour-Session. All with settings for 10ms Latency.... I guess, Ubuntustudio 64 would run the same as good as 64Studio but I have not tested this.... hamish schrieb: > this is as far as I've got so far>>>>>>>>>>>>>>>>>>> > > freebob and a realtime kernel are installed already > > in /etc/udev/rules.d/40-permissions.rules > i changed > KERNEL=="raw1394", GROUP="disk" > to > KERNEL=="raw1394", GROUP="audio" Not recommended - make your user a member of group disk instead... > > then I reloaded udev : > # /etc/init.d/sudo udev restart > reload raw1394 device : > # sudo rmmod raw1394 > # sudo modprobe raw1394 > (only works with sudo - how can i change the permissions) I do not need to do this - works for me out of the box, since I am in group disk. > > [EMAIL PROTECTED]:~$ sudo jackd -d freebob > [sudo] password for hamish: > jackd 0.103.0 > Copyright 2001-2005 Paul Davis and others. > jackd comes with ABSOLUTELY NO WARRANTY > This is free software, and you are welcome to redistribute it > under certain conditions; see the file COPYING for details > > JACK compiled with System V SHM support. > loading driver .. > Freebob using Firewire port 0, node -1 > libiec61883 warning: Established connection on channel 0. > You may need to manually set the channel on the receiving node. > libiec61883 warning: Established connection on channel 1. > You may need to manually set the channel on the transmitting node. All the same on my laptop. > > but i can't get Qjackctl working properly Qjackctl cannot start with freebob on my laptop either, after starting jackd in a shellwindow, I can klick start in Qjackctl. It shows "active" as the status and provides the ports OK in the connections-panel. Works very much OK for me.... -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.6 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iD8DBQFHQwOK1Aecwva1SWMRAnXQAJ9s8dMnnAHB5+QCmNgqxp3pXynkjwCfe9jN OYrcow8ydqNavVneejZ3xYI= =lKff -----END PGP SIGNATURE----- -- Ubuntu-Studio-users mailing list [email protected] Modify settings or unsubscribe at: https://lists.ubuntu.com/mailman/listinfo/ubuntu-studio-users
