Hi Hugo,
the board has only 1Mbyte of SRAM. Guess it runs out of memory.
best regards
Dani
Hugo Laurent Beaucage wrote:
Hi all,
i am working with uCLinux with ARM Cortex-M3 arch. The target board is
an STM3210F_eval board from ST compagny. The compagny has released
some patch to add their board with the 2008 distro so it can support
their board. I'm able to make it boot and install my micro SD wifi
drivers. Everything goes fine until i add the wireless network stack
and try to boot. Compilation goes well without error but the board
seems dead when i try to boot it. I recompile and remove the network
stack and it comes alive. The same problem occurs when i try to add
TCP/IP protocol, UNIX socket and Packet socket!!!! I was wondering if
someone had the same problem or is the error is known?
Here is some specs
jffs2 file system
around 2 Mbytes of flash on the board
serial port
micro SD wifi -> SDIO spectrec 823 wifi b/g
Thanks
Hugo
------------------------------------------------------------------------
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
