I do a lot of marine electrical and find the best method I use is to get a 100 foot spool of cheap automotive wire sixteen gauge and put two alligator clips on each end. You need to un spool it then coil it like a line you don't need the whole thing just enough to go under dash and back to your battery. You may want to install a small auto fuse I use the newer blade type with a ten amp fuse you should use smaller then that , I use ten because I use this to test relays and such. Then connect the one end to the negative side of the battery and use the other side as the ground to the meter when you cheek for power If the light should be on and the meter reads 12 volt with the clip remove it and test the black wire to the light if it does not read 12volts then your ground is bad Also most ground wires are blacken color
-- You received this message because you are subscribed to the Google Groups "UnifliteWorld" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/unifliteworld?hl=en. For more options, visit https://groups.google.com/groups/opt_out.
