JackOfAll wrote: > I2S can be "tapped" from the default Wandboard carrier board if you are > competent with a soldering iron. > > I don't want to go into this in too much detail now, but there will be a > basic I2S driver, as well as a codec driver for the community board, and > if I choose to release, (undecided yet, as I don't want to be > responsible for support if I can't upstream), a codec driver for a > couple of other specific chipsets as well. eg. ES9018. (I2S and I2C > control.) > > I'm not familiar with your nickname. Are you one of the guys from the > other forum with Ian's FIFO board, wanting to drive it directly from the > Wandboard? There will be a guide for those "advanced DIY'ers" released > at the same time as the driver bundle and device tree configuration > files. Being dependent on the mainstream kernel and F20 release, that's > not going to be released until next month.
I'm competent with a soldering iron. In due time i would appreciate any hints where to find the needed points. I plan to interface it to a tda1543 so I don't need any more than the 3 I2S lines, and the driver of course. I'm not active om the Ians fifo board. At the moment I'm using a waveIO. I mainly lurk and try to learn from the posts. When not clear I post a question myself. Thanks, marco ------------------------------------------------------------------------ deduikertjes's Profile: http://forums.slimdevices.com/member.php?userid=59474 View this thread: http://forums.slimdevices.com/showthread.php?t=99395 _______________________________________________ unix mailing list unix@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/unix
