JackOfAll wrote: > Bruno, > > Same again..... I can figure out what is going on here, but from a > complete dummy perspective, if you could write a sentence or two to > document it, that's something else that could be added to on-line > documentation, along with the script, rather than it getting buried in > the middle of this thread. > > EDIT: 20140115 12:41 > > And in the case of combining electronics, (even simple), with software, > assume that you need to explain everything..... (and I'm just plucking > this out of thin air) eg. there will be 5V driving the LED. The forward > voltage drop of the LED is 2V, and 10mA is a reasonable current to run > through it, so we need to drop 3V @ 10mA with a series resistor. 3/0.01 > = 300R resistor value. Explain the LED is a polarized device and that it > needs to be connected this way round..... That sort of thing.
Bruno Can I just add that the script needs to be running all the time to continually monitor the switch state. Where is the script located and how is it initiated. I can guess but better if we know... 1 x Touch - LMS 7.8.0 1 x Radio 1 x Boom Lavry DA-10 DAC HP PC as main Media Server QNAP TS-509 3.6.1 running SSOTS v4.14 Starfish Pre-amp : Based on NAIM Heavily modified NAIM NAP 250 Power-amp Behringer DEQ2496 Linn Isobarik DMS ------------------------------------------------------------------------ bobertuk's Profile: http://forums.slimdevices.com/member.php?userid=30376 View this thread: http://forums.slimdevices.com/showthread.php?t=99395 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
