BNAL wrote: > Yesterday I tried to give Squeeze Arch a try. Now I'm not a Linux guy, > but I have been able to do the basics and get CSOS working on my > Wandboard Quad and standing up a few Raspberry Pi's. > > I use my Wandboard to load the microsd with the OS. When I place the new > microsd in the pc slot and turn the board on and scan for the IP it is > using I don't see the board. I have left the board on for at least 20 > minutes, but still do not see the Wndboard when I scan for it using an > IP scanner. > > It seems obvious that I must be doing something wrong, but not sure what > it is. I run the first script and it appears to go out and pull some > data off the web: > wget > https://raw.githubusercontent.com/SqueezeOnArch/soa-installers/master/create-sdcard-soa-wand.sh > > The second script does not appear to do anything. I just get my prompt > after entering the code. > chmod 755 create-sdcard-soa-wand.sh > > The last script takes a while to run and appears to load Squeeze Arch on > the card. I let it run until the root prompt appears. > sudo ./create-sdcard-soa-wand.sh quad /dev/mmcblk1 > > Thanks in advance for the help figuring this out.
Sounds like you are doing the right thing as long as the card being installed to is in the sd slot of the wandboard carrier. Suggest trying again? I assume you don't have access to a serial cable to see what the wandboard is doing when it boots? ------------------------------------------------------------------------ Triode's Profile: http://forums.slimdevices.com/member.php?userid=17 View this thread: http://forums.slimdevices.com/showthread.php?t=101624 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
