kingswindsor wrote: > Sorry if I am being dim but what exactly is the command to run pikeyd > from the command line? When I try running it with the -pu switch it > says there is a syntax error - only start stop or status with no > options. I've stopped both Slimmer and Pikeyd.
OK I was being dim. Now have progressed but still not getting any evtest reports from the rotary encoder. Any advice gratefully received. The steps I have been through are:- - reboot - stop slimmer and pikey - checked using top - sudo pikeyd -pu Config file is /etc/pikeyd.conf Polling 2 GPIO pin(s). Found 0 I/O expander(s). Ready. Joystick init OK. Press ^C to exit. - Open new terminal - check running via top - OK - tce-load il evtest - evtest /dev/pikeyd ..................... Event code 250 (?) Event code 251 (?) Event code 252 (?) Event code 253 (?) Event code 254 (?) Event code 255 (?) Properties: Testing ... (interrupt to exit) Twiddle rotary encoder - nothing...... Just as a reminder, the pikeyd.conf file contains ROT 23 24 KEY_LEFT KEY_RIGHT Any obvious mistakes? ------------------------------------------------------------------------ kingswindsor's Profile: http://forums.slimdevices.com/member.php?userid=61926 View this thread: http://forums.slimdevices.com/showthread.php?t=105819 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
