kidstypike wrote: > It arrived! > > Couple of points, I'm not sure if you're not mistaken, but the endplate > with the cutout for the SD card is acrylic and is at least twice the > thickness of the other plate which is steel. > The manufacturers should really think about pre-tapping the holes for > the endplate screws, it's extremely difficult to cut a thread with the > supplied machine screws. I used the four screws that would eventually be > used for the back plate (and thus out of sight) to pre-tap all the > holes, using a T10 bit in a cordless drill on low speed. Even this > wasn't easy! > > Other than that everything fits and looks good - not a wire in sight. I > stuck four small rubber self-adhesive feet on the base. It does it's > job, and as a bonus it sounds fantastic. ;) > > > Thanks. > > 27014
I think in hindsight you are correct about end plates. The lack of pre drilled holes is the single biggest design flaw. I did what you did and used one set of screws for both ends. Some rubber feet would cost 2p or 3p? ------------------------------------------------------------------------ d6jg's Profile: http://forums.slimdevices.com/member.php?userid=44051 View this thread: http://forums.slimdevices.com/showthread.php?t=110346 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
