Man in a van wrote: > what have you done so far ? > > ronnie
Please note I am a newbie in linux. After I burned the image file of picoreplayer 8.0.0 (standard edition) to the SDcard (with balenaEtcher) I made the following: 1) I downloaded the bcm2710-rpi-zero-2.dtb file from 'here ' (https://github.com/raspberrypi/firmware/blob/master/boot/bcm2710-rpi-zero-2.dtb) and copied to the boot folder (as of Paul's post #4) using windows file explorer 2) I added the PI02 section in config.txt (editing with notepad++ in windows) 3) I edited the wpa_supplicant.conf with ssid and password of my wifi network and put it in boot folder 4) I downloaded the bcm2710-rpi-zero-2.dtb file from 'here ' (https://repo.picoreplayer.org/repo/13.x/armv7/tcz/firmware-rpi-wifi.tcz). 5) I am not sure how to do the next step. Anyway I plugged a USB card reader (with the above SDcard) to the RPi4 running the LMS and then I used WinSCP utility. I replaced the original file in /tce/optional folder I found under /mnt/ directory. (I suspect that this may be wrong but it was the only one /tce/optional folder I found). The result so far is that the Pi zero2w boots but does not find my wifi network Question: - Is the location where I put the file bcm2710-rpi-zero-2.dtb correct? - Do I have to mount the USB card reader somehow to the Pi4 or just plug it in a USB port is enough? 36152 +-------------------------------------------------------------------+ |Filename: IMG_20211113_211134res1000.jpg | |Download: http://forums.slimdevices.com/attachment.php?attachmentid=36152| +-------------------------------------------------------------------+ ------------------------------------------------------------------------ KaPa's Profile: http://forums.slimdevices.com/member.php?userid=72144 View this thread: http://forums.slimdevices.com/showthread.php?t=115331 _______________________________________________ unix mailing list unix@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/unix
