Hi again,
This is quite bizarre. As I mentioned in my previous email on this
topic, I have just got a new Powerlogix Powerforce G3/300/512k card for my
7300.
I have been unable to get it to boot OSX which was running fine up
until I inserted the G3 card & it runs 9.1 fine.
However, when I use XPostFacto to restart from the OSX partition,
the machine restarts with the correct chime, but the monitor never comes on
& the hard drive sits there spinning.
I refitted the riginal processor card & te first couple of tries,
it wouldn't reboot - hwoever, after a few tries, it now boots OSX fine.
I have not changed the bus speed on the card (still in stock
config). Can anyone help here?
Bye for now, Terry Allen
___________________________________________________________________
hEARd
Postal Address:
hEARd
c/o 128 The Entrance Rd
The Entrance
NSW 2261
Australia
Internet -
WWW:
http://heard.com.au or http://www.ozemail.com.au/~hmag
http://hosting.heard.com.au
Interactive Message Board - http://heard.com.au/wwwboard/
EMAIL: (checked every Thursday & Sunday, sometimes more often)
[EMAIL PROTECTED]
-----------------------------------------------
Non profit promotion for new music - since 1994
-----------------------------------------------
Also, check out the Educate site - http://www.educate.net.au
--
Unsupported OS X is sponsored by <http://lowendmac.com/>
Support Low End Mac <http://lowendmac.com/lists/support.html>
Unsupported OS X list info <http://lowendmac.com/lists/unsupported.html>
Send list messages to: <mailto:[EMAIL PROTECTED]>
To unsubscribe, email: <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive <http://www.mail-archive.com/unsupportedosx%40mail.maclaunch.com/>
Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
