Terry, I have the exact same problem. I have a Powerforce G3/500 and its stops right after the chime. I've tried different speed/bus settings. I had the card installed when I tried to use Xpostfacto to install OSX but it kept stalling after the chime. I removed all my PCI cards and that didn't work. I then re-install the original processor and I was then able to install OSX. However, I can't reboot into OSX but it's ok going into 9.1. I too would like to know if there's fix or a work around for this problem.
If you do find out how to boot into OSX, please let me know and I'll do the same. Norm >Hi again, > This is quite bizarre. As I mentioned in my previous email on this >topic, I have just got a new Powerlogix Powerforce G3/300/512k card for my >7300. > I have been unable to get it to boot OSX which was running fine up >until I inserted the G3 card & it runs 9.1 fine. > However, when I use XPostFacto to restart from the OSX partition, >the machine restarts with the correct chime, but the monitor never comes on >& the hard drive sits there spinning. > I refitted the riginal processor card & te first couple of tries, >it wouldn't reboot - hwoever, after a few tries, it now boots OSX fine. > I have not changed the bus speed on the card (still in stock >config). Can anyone help here? > > > Bye for now, Terry Allen > ___________________________________________________________________ -- Unsupported OS X is sponsored by <http://lowendmac.com/> Support Low End Mac <http://lowendmac.com/lists/support.html> Unsupported OS X list info <http://lowendmac.com/lists/unsupported.html> Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive <http://www.mail-archive.com/unsupportedosx%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
