> put "fred.txt" into filename
>
> open file filename for read
> put 1 into i
> repeat
> read from file filename until EOF
> put it into field field1 of card i
> end repeat
> close file filename
>From what it looks like, your just taking the data from the same file and
putting it into a field on each card. What I would recomend is that you
open the file and read the data only once, then close the data. Then go
through each card and put it into the field that you want.
Try this...
put "fred.txt" into fileName
open file fileName for read
read from file fileName until eof
put it into fileData
close file fileName
repeat with x=1 to the number of cards
put fileData into field "field1" of card x of this stack
end repeat
That's pretty much the same thing you are trying to accomplish, but should
run much faster.
Derek Bump
Dreamscape Software, Inc.
http://www.dreamscapesoftware.com/
_______________________________________________
use-revolution mailing list
[EMAIL PROTECTED]
http://lists.runrev.com/mailman/listinfo/use-revolution
