Here is what I would use:
on setTime theTime
if the paramCount > 1 then
repeat with i = 2 to the paramCount
put comma & param(i) after theTime
end repeat
end if
answer "setTime time is" && theTime
end setTime
Alternatively, you could replace the commas with something else before sending and put them back after sending.
Cheers,
Sarah
On Monday, January 20, 2003, at 07:36 am, Rob Cozens wrote:
Hi All,
Put these handlers in a button, enter a time in dateItems (eg: 2003,1,19,9,26,0,0) and see what you get.
on mouseUp
ask "Enter the time in a format that converts to dateItems."
if it is empty then exit mouseUp
put it into theTime
answer "The time is"&&theTime
send "setTime"&&theTime to me in 20 milliseconds
end mouseUp
on setTime theTime
answer "setTime time is"&&theTime
end setTime
When I run this in v1.5A7, mouseUp says theTime is 2003,1,19,9,26,0,0; but setTime says theTime is 2003. I worked around the problem by converting theTime to seconds before passing it...but (a) I shouldn't have to, and (b) I am concerned about the broader implications of sending any list that is input via an ask dialog (or in general?).
Rob Cozens
CCW, Serendipity Software Company
http://www.oenolog.com/who.htm
"And I, which was two fooles, do so grow three;
Who are a little wise, the best fooles bee."
from "The Triple Foole" by John Donne (1572-1631)
_______________________________________________
use-revolution mailing list
[EMAIL PROTECTED]
http://lists.runrev.com/mailman/listinfo/use-revolution
_______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
