Hi,
I wasn't able to see similar behavior in a test model where i made
hundreds of copies of a nurbs and added points.
2 thots...
1. Are you sure you don't have snap to grid selected, and maybe the
units are too far apart for the point to find a home?
2. Try downloading the latest demo version, which should be more current
then 4.5 (check me on this), and see if that does it.
chris mungenast
PS. take a look at Robert's site for some cool news about v5 sp3 and v6
[EMAIL PROTECTED] wrote:
Hi, I am getting very annoyed by some freak behaviour of the RS3D
NURBS curves. I am working a lot with polygonal NURBS curves in my
model, but sometimes the "Add point" method fails!
Usually it does add the point, just nowhere near the location where I
click. And no, the view is in perfect alignment and not in perspective
mode. More recently, the problem has escalated to a state where "add
point" doesn't even add a point! Nothing happens when the tool is
activated. I do see the green x indicating where the point should
appear, but then nothing happens. The curve still has the same number
of points. However, when I click "undo", again nothing happens. This
implies that some action was registered in the undo buffer.
To make matters more confusing, I can add points on some segments of
the curve and not on others.
Is this a known problem in v4.5? Is there a workaround?
Regards,
Fredrik Bergholtz
