Hi Keith Thank you for your reply. Could you please check my output at: https://asciinema.org/a/182678
I get this error: > PMD: eth_ixgbe_dev_init(): The EEPROM checksum is not valid: -1 any comment would be appreciated On Mon, May 21, 2018 at 5:26 PM, Wiles, Keith <[email protected]> wrote: > > > > On May 21, 2018, at 4:37 AM, Milad Arabi <[email protected]> wrote: > > > > Hi there > > I try to with dpdk 17.08 on centos7.5 with other library,but I got this: > > > >> [INFO] Initializing DPDK. This will take a few seconds... > >> EAL: Detected 16 lcore(s) > >> EAL: Probing VFIO support... > >> EAL: PCI device 0000:0b:00.0 on NUMA socket -1 > >> EAL: Invalid NUMA socket, default to 0 > >> EAL: probe driver: 15ad:7b0 net_vmxnet3 > >> EAL: PCI device 0000:13:00.0 on NUMA socket 1 > >> EAL: probe driver: 8086:10fb net_ixgbe > >> EAL: PCI device 0000:13:00.1 on NUMA socket -1 > >> EAL: Invalid NUMA socket, default to 0 > >> EAL: probe driver: 8086:10fb net_ixgbe > >> *[INFO] Found 0 usable devices:* > > > > > > are these errors come from dpdk? and how I can solve this problem? > > Did you use the dpdk-devbind.py tool in dpdk to bind the device to allow > DPDK to use the device? > > Also you may have to insmod the igb_uio.ko for pci_uio_generic modules in > the kernel? > > > > > # ethtool -i ens224f1 > >> driver: ixgbe > >> version: 5.3.7 > >> firmware-version: 0x80000835, 1.949.0 > >> expansion-rom-version: > >> bus-info: 0000:13:00.1 > >> supports-statistics: yes > >> supports-test: yes > >> supports-eeprom-access: yes > >> supports-register-dump: yes > >> supports-priv-flags: yes > > Regards, > Keith > >
