> On May 21, 2018, at 11:41 AM, Milad Arabi <[email protected]> wrote: > > Since I do not know anything about Eng-Sample NIC then no it's not. It is the > original Intel network card pass through to CentOS from VMware. > Do you think maybe the VMware cause this issue?
Could be, guess its back to google for passthru NICs in VMWare or how to set the NIC MAC address in VMWare. > > On Mon, May 21, 2018 at 8:55 PM, Wiles, Keith <[email protected]> wrote: > > >> On May 21, 2018, at 11:16 AM, Milad Arabi <[email protected]> wrote: >> >> Hi Keith >> Thank you for your reply. >> Could you please check my output at: >> https://asciinema.org/a/182678 >> >> I get this error: >> PMD: eth_ixgbe_dev_init(): The EEPROM checksum is not valid: -1 > > Normally that means this is a Eng-Sample NIC, is it? > > If it is then we have to find someone to program the EPROM to setup the NIC. > > That is about all I know. > >> >> any comment would be appreciated >> >> >> On Mon, May 21, 2018 at 5:26 PM, Wiles, Keith <[email protected]> wrote: >> >> >> > On May 21, 2018, at 4:37 AM, Milad Arabi <[email protected]> wrote: >> > >> > Hi there >> > I try to with dpdk 17.08 on centos7.5 with other library,but I got this: >> > >> >> [INFO] Initializing DPDK. This will take a few seconds... >> >> EAL: Detected 16 lcore(s) >> >> EAL: Probing VFIO support... >> >> EAL: PCI device 0000:0b:00.0 on NUMA socket -1 >> >> EAL: Invalid NUMA socket, default to 0 >> >> EAL: probe driver: 15ad:7b0 net_vmxnet3 >> >> EAL: PCI device 0000:13:00.0 on NUMA socket 1 >> >> EAL: probe driver: 8086:10fb net_ixgbe >> >> EAL: PCI device 0000:13:00.1 on NUMA socket -1 >> >> EAL: Invalid NUMA socket, default to 0 >> >> EAL: probe driver: 8086:10fb net_ixgbe >> >> *[INFO] Found 0 usable devices:* >> > >> > >> > are these errors come from dpdk? and how I can solve this problem? >> >> Did you use the dpdk-devbind.py tool in dpdk to bind the device to allow >> DPDK to use the device? >> >> Also you may have to insmod the igb_uio.ko for pci_uio_generic modules in >> the kernel? >> >> > >> > # ethtool -i ens224f1 >> >> driver: ixgbe >> >> version: 5.3.7 >> >> firmware-version: 0x80000835, 1.949.0 >> >> expansion-rom-version: >> >> bus-info: 0000:13:00.1 >> >> supports-statistics: yes >> >> supports-test: yes >> >> supports-eeprom-access: yes >> >> supports-register-dump: yes >> >> supports-priv-flags: yes >> >> Regards, >> Keith >> >> > > Regards, > Keith > > Regards, Keith
