Hi Ashwani,
Thank you very much.
I changed smsc_smpp.c file and installed kannel freshly and now it is
working.
Thanks & Regards,
Samir.
On 9/14/07, ashwani <[EMAIL PROTECTED]> wrote:
>
> Hi Samir,
>
> I faced the similar problem while integrating with one of the operator's
> SMSC. In that case, SMSC was sending messages with "ton =1" which means
> international. Now, as per SMPP 3.4, international ton would require
> destination address of at lest 7 digit. Since the destination address was
> a
> shortcode and hence less than 7 digit, kannel was throwing this error
>
> To resolve this issue, we had to change in kannel smpp file where we
> reduced
> the minimum digit of destination number to 4
>
> Go to /server-location of kannel/gateway1.4.1/gw/smsc
>
> Edit file named smsc_smpp.c and change
>
> if (octstr_len(addr) < 7) {
>
> to
>
> if (octstr_len(addr) < 4) {
>
> And then recompile the kannel i.e install the kannel freshly.
>
> Hope this will help
>
> Regards
> Ashwani Kumar
>
>
>
> -----Original Message-----
> From: Jean-Claude Adams [mailto:[EMAIL PROTECTED]
> Sent: Thursday, September 13, 2007 9:32 PM
> To: Samir Ghodasara; Kannel Users
> Subject: Re: gateway-1.4.1 and Mallformed addr `****', expected at least
> 7digits.
>
> Hi:
>
> I guess your are received '+' or any character prefix.
>
> You can solve this in your smsc group:
>
> address-range = "^99011$"
> source-addr-ton = 5
> source-addr-npi = 0
> source-addr-autodetect = true
> dest-addr-ton = 4
> dest-addr-npi = 0
> bind-addr-ton = 0
> bind-addr-npi = 0
> msg-id-type = 0x01
>
> Samir Ghodasara wrote:
> > Hi,
> >
> > i am new user for Kannel and currently trying to configure kannel to
> > receive the message for give short code.
> >
> > I configure kannel for two different SMSC for same short code.
> > I am able to receive message from one SMSC,but while using other SMSC
> > mobile i am getting
> > "Mallformed addr `****', expected at least 7 digits." at Bear box.
> >
> > Conf which i am using..
> >
> > gateway-1.4.1
> > source-addr-ton=1
> > source-addr-npi=1
> > dest-addr-ton=1
> > dest-addr-npi=1
> > transceiver-mode=true
> >
> > I am really confuse that it is working for one SMSC and not working
> > for anhother SMSC.
> >
> > Waiting for your valuable response.
> >
> > Thanks & Regards,
> > Samir.
> >
>
>
> --
> Jean-Claude Adams
> Encargado de Sistemas
> PICO S.A.CI.
> Tel. +595 21 665052
> Cel. +595 981 833415
> email: [EMAIL PROTECTED]
>
>
>
>
>
>
>
