Hmmm. I had tested it also with Openwave simulator, with no problems. Same code is used in my commercial gateway in major ISPs (real mobile traffic) without such problems either. It has been tested and developed using openssh-0.9.8.[g,h]. Maybe there is something there.
Does this happen only with Openwave, and the 2 mobiles you mentioned, or with just about anything you have tried? Please post new detailed wapbox logs of 1 failed attempt. Compile with debug CFLAGS (-g -Wall -- remove -s or -Ox) and if possible upload somewhere the core for me (can send details personally). If not post the gdb core function stack (use: where) BR, Nikos 2011/7/6 Armindo Antunes <[email protected]> > Nikos, thanks for the feedback! > See my questions below. > Best regards, > Armindo Antunes > > On 06-07-2011 17:27, Nikos Balkanas wrote: > >> Hi, >> >> Look at the openssl site for certificate instructions. It is not kannel's >> responsibility. >> >> Make sure that certificates are self-signed and without password. Comment >> out privatekey-password from wtls configuration and retry. >> > > Still the same behavior... any other idea? > > > >> Alex: >> >> There was a section in UG about wtls configuration. It even included >> certificate generation instructions. Apparently this was removed. Now, that >> wtls is supported again, it should be put back. >> > Is it possible to recover this information? At least the certificate > generation instructions? > > Thanks again, > Armindo > >
