Thanks, I'll try that.
Armindo
On 06-07-2011 21:17, Nikos Balkanas wrote:
Hmmm. I had tested it also with Openwave simulator, with no problems.
Same code is used in my commercial gateway in major ISPs (real mobile
traffic) without such problems either. It has been tested and
developed using openssh-0.9.8.[g,h]. Maybe there is something there.
Does this happen only with Openwave, and the 2 mobiles you mentioned,
or with just about anything you have tried?
Please post new detailed wapbox logs of 1 failed attempt. Compile with
debug CFLAGS (-g -Wall -- remove -s or -Ox) and if possible upload
somewhere the core for me (can send details personally). If not post
the gdb core function stack (use: where)
BR,
Nikos
2011/7/6 Armindo Antunes <[email protected]
<mailto:[email protected]>>
Nikos, thanks for the feedback!
See my questions below.
Best regards,
Armindo Antunes
On 06-07-2011 17:27, Nikos Balkanas wrote:
Hi,
Look at the openssl site for certificate instructions. It is
not kannel's responsibility.
Make sure that certificates are self-signed and without
password. Comment out privatekey-password from wtls
configuration and retry.
Still the same behavior... any other idea?
Alex:
There was a section in UG about wtls configuration. It even
included certificate generation instructions. Apparently this
was removed. Now, that wtls is supported again, it should be
put back.
Is it possible to recover this information? At least the
certificate generation instructions?
Thanks again,
Armindo
