On 02/03/2010 04:22 PM, Iñaki Baz Castillo wrote:
However this trick is not needed at all to fix just the signalling as the
"Contact" URI (so the dialog target uri) was already replaced in the initial
INVITE/200, and it cannot change within a dialog.
Checked the RFC, you are right.
Then, what the OP must be implying is that the PSTN UA is not following
original Contact/dialog target URI bound at start of dialog and is
following new Contact (with RFC1918 address) sent in re-INVITE?
--
Alex Balashov - Principal
Evariste Systems LLC
Tel : +1 678-954-0670
Direct : +1 678-954-0671
Web : http://www.evaristesys.com/
_______________________________________________
Kamailio (OpenSER) - Users mailing list
[email protected]
http://lists.kamailio.org/cgi-bin/mailman/listinfo/users
http://lists.openser-project.org/cgi-bin/mailman/listinfo/users
