Hi,
As mentioned, place the avp_print() just after you did the
ds_select_dst(), before relaying to the first destination.
Regards,
Bogdan-Andrei Iancu
OpenSIPS Founder and Developer
http://www.opensips-solutions.com
On 17.09.2014 14:09, Satish Patel wrote:
Confirmed probing/inactive thing is working,
Now problem is failover not working, ds_next_dst() not able to find next
gateway and it says no more gateway available. If you check my script, i am
calling failure route and inside it calling ds_next_dst() but you are saying do
avp_print() on ds_select_dst() it won't print anything because after failure
you are in failure route block.
Please advice if my script has any issue.
Sent from my iPhone
On Sep 17, 2014, at 3:30 AM, Bogdan-Andrei Iancu <[email protected]> wrote:
Hi Satish,
Use the "opensipsctl fifo ds_list" to see the status of the gws in realtime .
Be sure that once a gw is in non-active state (probing or inactive), it will not be used
again for routing. Just take care of doing the ds_next_dst() in order to jump to the next
available gw.
If you do the avp_print() after ds_select_dst(), you can see how many other gw
are prepared to used in case of failover.
Regards,
Bogdan-Andrei Iancu
OpenSIPS Founder and Developer
http://www.opensips-solutions.com
On 16.09.2014 21:02, Satish Patel wrote:
After doing couple of TEST look like its marking "Probing" for failed gateway
but not auto failover to next gateway, i meant call get disconnect and i need to
re-initiate call then all call goes to second active gateway..
I believe it should first mark gateway "Probing" and then fall-back to second
gateway automatically instead of call disconnect and i am getting 503 error code on my
SIP Phone.
_______________________________________________
Users mailing list
[email protected]
http://lists.opensips.org/cgi-bin/mailman/listinfo/users
