Le 10/09/2017 à 17:37, Claus Futtrup a écrit :
Hi Samuel
Thanks for all the (different email) responses - and below tip how to
directly put the figure size with the scf() command. This directly
answers my initial question. Thanks.
How do you guys figure this out? Looking directly in the Scilab
source-code? :-)
That's right, Claus, this new feature named "Recursive extraction" is
not documented (*), and even not announced in the 6.0.0 CHANGES page!
Apparently, it must remain confidential. It was just announced at the
last 2015 Scilabtech, and already sometimes addressed in this ML.
(*) http://bugzilla.scilab.org/14211#c6
Best regards
Samuel
_______________________________________________
users mailing list
[email protected]
http://lists.scilab.org/mailman/listinfo/users
