Hi Andreas,
ip route list works fine on my target board. but ip xfrm state did not work.
When I type "ip xfrm state",
it shows the following messages:
BusyBox v1.10.1 (2009-09-28 15:09:16 CST) multi-call binary
Usage ip [OPTIONS] {address | route | link | tunnel | rule} {COMMAND}
--- 09/9/30 (三)，Andreas Steffen <[email protected]> 寫道：
寄件者: Andreas Steffen <[email protected]>
主旨: Re: [strongSwan] ip xfrm state / ip xfrm policy
收件者: "Jessie Liu" <[email protected]>
副本: [email protected]
日期: 2009年9月30日,三,下午12:32
Hi Jessie,
in the past there are some embedded platform which did not implement
the ip xfrm command. Does e.g. "ip route list" work? If not then the
whole iproute2 package is missing and you must install it first.
Regards
Andreas
Jessie Liu wrote:
> Hi all,
> I'am trying to use " ip xfrm state " and " ip xfrm policy " command.
> But I couldn't use that command to show information. There is no such command!
> What else should I add in kernel config?
> I already have xfrm4_tunnel.ko and xfrm_user.ko, but still cannot use that
> command.
>
> Thanks a lot. ^_______^
======================================================================
Andreas Steffen [email protected]
strongSwan - the Linux VPN Solution! www.strongswan.org
Institute for Internet Technologies and Applications
University of Applied Sciences Rapperswil
CH-8640 Rapperswil (Switzerland)
===========================================================[ITA-HSR]==
___________________________________________________
您的生活即時通 － 溝通、娛樂、生活、工作一次搞定！
http://messenger.yahoo.com.tw/
_______________________________________________
Users mailing list
[email protected]
https://lists.strongswan.org/mailman/listinfo/users
