Hi Michael,
I'm not aware of any memory leak that we fixed. You could run charon
compiled with the --enable-leak-detective configure option and check
for any memory leaks when you stop the daemon.
Regards
Andreas
On 05.08.22 09:46, Michael Schwartzkopff wrote:
Hi,
we have a strongswan 5.9.5 installed on a embedded device.
We see a increase of memory usage of the charon process of about 200
kB/hour.
The leak might be somehow connected to rekeying since the leak rate was
reduced with the rekeying rate. Also perhaps to logging, since we
reduced verbosity to decrease leak rate.
As far as I read the changelog, no memory leak was fixed in 5.9.6 and
5.9.7.
Any idea how to proceed to pin down the cause of the leak? 200 kB/h
impacts the embedded device.
Mit freundlichen Grüßen,
======================================================================
Andreas Steffen [email protected]
strongSwan - the Open Source VPN Solution! www.strongswan.org
strongSec GmbH, 8952 Schlieren (Switzerland)
======================================================================
