I have tested before render response but does'nt work because, the first time I call the page, in befer render response phase the view root is empty.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Craig McClanahan Sent: 27 febbraio 2007 23.50 To: MyFaces Discussion Subject: Re: Change visibility dinamically On 2/27/07, Volker Weber <[EMAIL PROTECTED]> wrote: > 2007/2/27, Craig McClanahan <[EMAIL PROTECTED]>: > > On 2/27/07, Volker Weber <[EMAIL PROTECTED]> wrote: > > > > The places where the rendered flag is referenced are actually: > > > > * In Apply Request Values ... decoding of request parameters > > will not occur if rendered (or visible) is set to false. > > also in processValidations and processUpdates, both are skiped if > rendred is set to false. > > > > > * In Render Response ... rendering will be completely skipped > > if rendered is set to false. > > > > In between these times, the rendered property is most likely not being > > referenced, so changes are safe. > > I don't think you get the expected results if you change on other > places than between after updateModel and before renderResponse. > In case of validation/conversion errors all of them exept before > renderResponse are skipped. > Good catch ... I forgot to check the processXxxx methods for those phases. So, the advice that before render response seems like the point to change the value stands. > Regards, > Volker > Craig This message is for the designated recipient only and may contain privileged, proprietary, or otherwise private information. If you have received it in error, please notify the sender immediately and delete the original. Any other use of the email by you is prohibited.
