I was looking for some icon or button to select a connector and add
another bend. I can create them fine, but it starts with 2 bends.. so
way to add more.
-- bk
G. Roderick Singleton wrote:
On Mon, 2005-06-27 at 14:37 -0400, Bryan Kearney wrote:
I am not seeing it in the format tool. Any idea where it would be?
Not sure I understand. Connectors are described in the user guide
( http://tinyurl.com/5u8bt ) around page 277 in the impress section with
back references from draw as they much the same.
As to where one finds the toolbar, look on the mail toolbar (usually on
the left) for an icon with a curly line terminated with boxes when you
are in draw or impress.
Also... I assume that odraw is now sdraw?
Thanks!
-- bk
don't know as I always use <some path>/soffice -[writer calc draw etc]
to invoke the module or use what is in the menues
G. Roderick Singleton wrote:
On Mon, 2005-06-27 at 13:49 -0400, Bryan Kearney wrote:
I scanned the doco, and did not see anything on this. It appears that in
Open Office Draw version 1.1.2 that you can not have more then 2 bends in a standard
connector (making three "lines"). Is there a means of adding additional
bends to get more sophisticated routing?
Try upgrading to 1.1.4. The problem may have been solved.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
